WLAN Pi M4/+ Case

Only recommended for people who want a challenge!

What exactly is included:

• case extrusion (orange, PETG)

• 2x end caps (PETG)

• support sled (PETG)

• v-plane antenna riser (PETG)

• vanity plate (PETG)

• shroud (PETG)

• quarter inch thread assembly (black, PETG)

• threaded magnet slugs (PETG)

• button pad (black, flexible filament)

• Joystick cap V2 (black, injection moulded)

• 2x threaded inserts (for Joystick cap V2 application)

• 14x black countersunk M3 machine screws

• 8x M3 nuts

• GPIO pin riser

• 2x PCB antennas

Currently there is not a step-by-step assembly guide for the WLAN Pi M4/+.

Please only purchase this case only bundle if you are actively seeking self-assembly without instructions.

What is the difference between the variants available?

M4

3D printed end caps and vanity plate are ‘light grey PETG’, end cap geometry is tuned towards the Mcuzone WiFi 6E expansion board.
“CM4 wifi6 WiFi 6E expansion board,Raspberry Pi Compute Module 4, Intel AX200 AX210 PCIe M.2 A Key”

M4+

3D printed end caps and vanity plate are ‘dark grey PETG’, end cap geometry is tuned towards the Mcuzone WiFi 7 expansion board (please note the WLAN Pi M4+ uses a custom variant of this board with PCB mounted OTG toggle switch). Ethernet end cap possesses OTG toggle switch cutout.

Screen module

Waveshare 1.44” screen & 3 button array. What is special about this? A ‘threaded insert’ is ‘pre-thread’ onto the joystick peg, enabling a secure friction fit for the joystick cap V2.